Axiohm 7156 Especificações descarregar pdf (Página 63)

7156 Owner’s Guide Diagnostics

October 1995 55

Testing the Slip and Receipt Stations

These functions allow you to select various tests to check slip and receipt

printing. It is the only way to run the print test on the slip station. You can also

run a print test on the receipt station without changing the DIP switches by

following the procedures in “Print Test” later in this chapter.

Print Sample Check Via Feed Button

This test prints a sample check. Because blank checks are not all laid out the

same, the information may not line up perfectly on the blank check you use.

Caution: The DIP switches are set at the factory to predetermined settings and

should generally not be changed. If you must change the settings do so carefully

to avoid changing other functions.

1. Open the front cover and set the DIP switches to the following settings:

Switch 7 is always Off. Switch 8: On = knife, Off = non-knife

Switch 1 Switch 2 Switch 3 Switch 4 Switch 5 Switch 6

On Off Off Off Off Off

2. Close the front cover and press the On Line button.

3. Insert the blank check.

The green LED comes on indicating the check is in the proper position.

4. Press the Paper Feed button to print the sample check.

The check is fed back out.

5. Press the Paper Feed button to open the platen so you can remove the check.

6. Repeat steps 3-5 to print another sample check, or go to step 7 to stop.

7. Set the DIP switches back to the settings for normal operation (on-line mode).

See “Switch Settings” in the “Communication” chapter for the settings.

8. Close the front cover and press the On Line button.

The green LED flashes when the printer cycles.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 189 190

Sem comentários

Axiohm 7156 Especificações Página 63